So today I will tell you all about The Trending Fashion essential on 2014.Fashion changes so fast and bring back an old trends such as vintage and simple outfits but it comes with a gorgeous essentials.
let's begin with CLUTCH :)
First CLUTCH brings a new look for this year. many clutch comes with different pattern and materials. Envelope clutch take a 1st place.
there is transparant clutch too and its very easy to make by your self
i will give you the tutorial of making diy transparant clutch :) You need:
A 46 cm x 46 cm clear PVC square, mine was 3mm thick
Pen
Ruler
Scissors
Multi hole punch
5 round top studs with screws
46 cm x 46 cm square cardboard
Adhesive tape
1 meter long chain
Embellished bracelet
Cutting pliers
Jewelery glue
Thread + needle
Ruler
Scissors
Multi hole punch
5 round top studs with screws
46 cm x 46 cm square cardboard
Adhesive tape
1 meter long chain
Embellished bracelet
Cutting pliers
Jewelery glue
Thread + needle
THE STEPS:
Draw the clutch template onto your cardboard following the measurements bellow.
Cut your template out and place your PVC on it. Stick it on with the adhesive tape and cut along the template sides.
Remove the PVC from the template and fold the corners over, side first and then bottom.
With your pen mark the 4 points where you will put your stud beads to secure the clutch shape.
Use the multi hole punch to perforate onto these marks (make sure to use the hole stick that have the same diameter than your stud screw one). Fix the stud pushing the screw from underneath and screwing the top on.
Figure out where will be placed the last stud that will act as a latch (it has to be on the middle of the clutch). Make a hole and screw the stud.
Fold the top PVC part over and mark with your pen the 3 points above the 3 top studs that will be your bag latch.
Make holes with your multi hole punch (using a hole stick with the same size than the stud rond part) and gently press the top PVC part to close your bag.
N.B: You can stop here to make a simply clear PVC clutch.
STEP TWO
Cut the sides of your bracelet with the clutting pliers.
Decide where you are going to put it, spread some glue at the back and gently place it on the bag. Let dry for 20 minutes or so.
Sew the bracelet to secure it on the bag. Is used a thread with a similar color than the metal of the bracelet to keep it invisible.
N.B: You can stop here to have a beautiful embellished clutch.
STEP THREE
Sew 1 or 2 links each side of the inner top flap, at the folding.
YAIIIY ITS ALL DONE :)
Comment below please ;)
